ECU Master TUNER3 Manuel de service télécharger pdf (Page 28)

Parametric output configuration

To configure the parametric output, choose the parameter window (Setup/Paramteric output configuration). In

the configuration window, choose inputs, which will be used as function parameters, referential values and

conditions, which fulfillment will activate the user output.

Parameters Source1, Source2 and Source3 allow to

choose the inputs. If interested in only one input, chose

None as Source2 and Source 3. For each input it is

possible to choose a condition that needs to be fulfilled

to activate an output. The Hysteresis (Hist.) is used to

define hysteresis value. This value defines the condition

for the output deactivation. For example, if the LED

diode is used as a shift light when the engine revolutions

are higher than 5000, and hysteresis will be defined at

the level of 500 revolutions, the LED diode will turn off

when the engine revolutions drops under 4500.

Additionally, between the conditions for the Source1, Source 2 and Source3, it is possible to define a condition

(AND, OR) which must be fulfilled to activate a parametric output.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Pas de commentaire

ECU Master TUNER3 Manuel de service Page 28